CONVERSION FOR SWIPE ELITE PLUS - 2016 EDITION

How to convert swipe elite plus

ABOUT:

This conversion is very crucial to install a custom rom on your swipe elite without it your phone can be permanently bricked.

PROCEDURE:

Step 1:

Restore the QCN from this Link: Link (For network coverages)

Step 2:

Connect your phone to PC in switch off mode

Hold down VOLUME UP+VOLUME DOWN+POWER

Voila you are in download mode

step 3:

Install proper adb driver for this phone

To check out this Right click on My computer>Device Manager>On the port you can see the qualcomm.

if you can see then install adb drivers properly for your phone

Step 4:

Download and Install the flash tool from here

Step 5:

After Completing intallation BACKUP your QCN file

Stat>All Programs>QPST>QFIL

then select TOOLS>QCN BACKUP RESTORE then backup your QCN. 

IF YOU CAN'T BACKUP YOUR QCN DON'T WORRY JUST DOWNLOAD IT FROM HERE

Step 6:

OpenMenu->QPST->QFIL

Phone power off, remove USB cable, hold volume buttons(both“+”and“-”),

Insert thedata cable and release the buttons after the red interface pops up;

Hold volumebutton (+) again until the mobile phone’s screen turn black

Release thevolume button again; the phone is already in downloading mode.

Port 9008will appear in the QFIL, if can not be identify 9008, pls click “select port”

Step 6:

Start to flash phone:

1.   ChooseFlat Build inSelect build type

2.   ClickBrowse, and choose “prog_emmc_firehose_8936.mbn” , then click search patch

3.   Click Load XML, and choose “rawprogram0_unsparse.xml” , and continue to choose  “rawprogram0.xml”

4.   Click“Download”to start

Step 7:

Restore your QCN

After flash, need to use QFIL to restoreQCN,

Open menu->tools->QCNbackup restore

ClickBrowse and select the file you backup one, then restore

Step 8:

After download complete HOLD your POWER BUTTON (10sec)

when the phone is powered a small linux logo appear.. then you all done! 

NOW YOUR DEVICE IS CONVERTED TO TCL M3G.

Step 9:

After Setup Complete SWITCH OFF the phone.

hold down VOLUME UP+POWER BUTTON to enter recovery

Then select Go to BOOT LOADER

Now Download This two Files

1. TWRP RECOVERY

2.  ADB DRIVER

Also Read:
xperia CM 13 ROm

                               

After downloading these files

Extract ADB Drivers then put twrp.img into that folder

Open command window then copy and paste the command "fastboot flash recovery twrp_en.img"

after completion turn on the device by holding the power button 

Congratulations

your device is converted with TWRP RECOVERY